Super Products Camel 1200 (Ejector Unloading) - Crushing Hazards and Prevention Safety; Debris Body Prop Support; Tailgate Prop Support; Truck Tip over

SAFETY
Publication: 0028607 1-7
1
CRUSHING HAZARDS AND PREVENTION SAFETY
Figure 1-6
Debris Body Prop Support

WARNING
1. Raise body sufficiently to allow body prop support to
be swung into position.
2. Slowly lower body until body contacts body prop
support.
• To remove body prop support, reverse above
procedure.
Tailgate Prop Support

WARNING
1. Raise tailgate sufficiently to allow tailgate prop
support to be swung into position.
2. Slowly lower body tailgate until tailgate contacts
tailgate prop support.
• To remove tailgate body prop support, reverse above
procedure.
Truck Tip Over

WARNING
• Truck driver must have valid and appropriate training
license before transporting liquids on public roads.
• Slow down on curves to prevent truck from tipping
over.
• Always ensure unit is on firm and level ground before
operating the dump system. When dumping, raise
the body in steps, allowing the material to dump out
in a steady flow.
• Do not allow people and/or vehicles beside debris
body while dumping.
• Never drive truck with raised debris body.
• Keep truck away from drop-offs and soft soil shoulder
where truck could tip over.
Never go under raised debris body until prop is
installed. Failure to do so could result in personal
injury or death.
Always position tailgate prop in proper position
before entering any areas beneath tailgate or
entering body. Failure to do so could result in
serious injury or death.
Always wear seat belt while seated in truck to
prevent injury.