Super Products Camel 1200 (Ejector Unloading) - Maintenance Items; Boom; Debris Body; Electrical System

6-6 Publication: 0028607
LUBRICATION AND MAINTENANCE
6
Maintenance Items
NOTE
See Lubrication Recommendation Chart for servicing
the Camel™ truck. If a product is unavailable, contact
Super Products for a recommendation of alternate
products.
Boom
• Apply grease through the distribution fittings weekly.
Figure 6-7
• Inspect boom bearing teeth for wear or cracking.
• The boom extension joint is a lifetime polymer slide.
No lubrication is necessary.
Debris Body
• Body Interior — Empty debris body daily and clean
interior using spray bar flushing system (if equipped)
or handgun. Clean tailgate sealing surface.
• Tailgate Seal — Clean the tailgate seal after each
discharge of debris with the use of the handgun.
Inspect the seal weekly for rips, tears, and proper
alignment with the body. Replace as necessary.
• Hydraulic Tailgate Latch Rollers — Clean the
tailgate latch rollers after each discharge. Lubricate
the rollers by hand with grease weekly and inspect
their condition. Repair or replace as necessary.
• Hydraulic Tailgate Latches — Clean any debris off
the latches daily. Lubricate the latch pivots and rollers
with grease weekly.
• Tailgate Lift Cylinder Pin — Inspect for wear.
Repair or replace as necessary.
• Float Ball — Clean the float ball daily or after each
load. Inspect the float ball weekly for dents and
proper sealing.
• Tailgate Hinge — Grease tailgate latch through the
grease zerk fitting (1) and distribution manifold (2)
weekly.
Figure 6-8
• Body Drain Valve and Hose — Inspect the valve for
proper sealing and the hose for leaks and wear
weekly. This applies to both rear and front drain (if
equipped).
• Debris Level Sensor (Option) — Make sure the
sensor is cleaned daily and after every debris dump.
Electrical System
• Lights — Make sure that all vehicle lights are
working properly.
• Pendant Plugs and Receptacles — Inspect the
pendant plugs and receptacles for proper contact
and alignment. Clean the terminals monthly and
lubricate them with dielectric grease.
NOTE
Avoid directly spraying electrical enclosures and
components with high-pressure water.
Boom Grease Distribution Fittings
Tailgate Grease Distribution Manifold
1
2