For misting applications, see instructions beginning in on page 29.
If you make a mistake while programming, the controller displays an error mes-
sage. Press the Clear key, then repeat correctly the last programming step.
Follow the instructions below to set your program(s); or to make changes, dele-
tions, or additions to the current program(s). Any program setting can be changed
without affecting the rest of the program. To erase existing pro-gram(s), follow
instructions on page 10.
To begin programming, turn the dial to a program (e.g., Program 1).
1. Set Current Time: Using the numbered keys, key in the current time. If it is
p.m., the next step is to press the PM/% key (the p.m. indicator will show up on
the upper left side of the display window). Next, press the Time key.
EXAMPLE A: Time is 11:38 a.m., press:
EXAMPLE B: Time is 4:35 p.m., press:
Note: Midnight is 12 00 am, Noon is 12:00 p.m.
2. Set Today: Key in the number corresponding to the current day of the week,
then press Today key.
EXAMPLE: Today is Tuesday, press:
Time and Today functions need only be entered once and will automatically apply
to all six programs. The remaining functions, covered in steps 3, 4, and 5 below,
apply only to the program indicated by the program dial and must be entered in
each program that is intended to operate automatically.
Page
11
BASIC PROGRAMMING INSTRUCTIONS
1
SUN
1
SUN
3
TUE
8
TIME
4
WED
3
TUE
3
TUE
TIME
5
THU
PM
%
TIME
To Next Page
Loading...
Need help?
General