SUPERIOR CONTROLS STERLING CONTROLLERS - Loop Cycle Management; Delay Between Cycles Examples; Manually Starting Loop Cycle

Page
24
EXAMPLE A: To schedule a 20 minute delay between cycles, press the follow-
ing keys:
EXAMPLE B: To schedule a delay of 2 hours and 30 minutes between cycles,
press the following keys:
To change the delay follow steps a thru d above entering the new time at step c.
To delete the delay, enter 0 at step c.
After programming has been completed (including steps 1-4 of Basic Program-
ming Instructions), watering will begin automatically at the next scheduled start
time (beginning of loop). To activate the loop cycle prior to then, follow the in-
structions below.
Manually Starting Loop Cycle
To activate a loop cycle at other than its scheduled start time (beginning of loop),
do the following:
a. Turn the dial to desired program.
b. Key in the first station intended to turn on.
c. Press Manual On/Off key. (Display will alternately flash station number
and remaining water time.)
d. Return dial to Auto position.
Note: If loop cycle is manually started, it will continue until its programmed end
time (end of loop) unless it is manually stopped before then.
Manually Stopping Loop Cycle: With dial at program in operation, press
Manual On/Off key.
STN
WATER
TIME
9
2
MON
3
TUE
0
ENTER
0
STN
WATER
TIME
9
2
MON
0
ENTER
0