Page
20
ADDITIONAL FEATURES
CYCLE
START/END
OPTIONS
Scrolling Cycle Start And End Times Of All
Programmed Cycle Starts: Press Cycle Start key and the
controller will display in sequence all programmed cycle starts,
first showing the cycle start number, then the cycle start time,
and then the cycle end time.
Note: Cycle end time will take into account the water budget
percentage.
If a loop cycle is programmed, “LOOP” is displayed as the
cycle end time.
To display the status of all 9 options, first turn the dial to Op-
tions position, then press Enter. The controller will scroll
through the options in sequence showing each as “On” or
“Of ” (Of = OFF).
Using Water Budgeting
This feature allows you to simultaneously change the watering time of all stations
within a program. The current settings can be increased or decreased within a
range of 1% to 255%, with 100% representing the programmed time.
For example, in the winter you may wish to water only 50% of the programmed
time.
To use Water Budgeting:
I. Turn dial to desired program.
2. Press the PM/% key. The controller displays the current water budget-
ing
% (e.g. 100 for 100%).
3. Key in the new percent value.
4. Press Enter key. The controller flashes the new percent value and an LED
located to the left of the display window illuminates to indicate that the
water budget percentage is other than 100.
To Next Page
Loading...
Need help?
General