EasyManuals Logo

SUPERIOR CONTROLS STERLING CONTROLLERS User Manual

SUPERIOR CONTROLS STERLING CONTROLLERS
35 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #34 background imageLoading...
Page #34 background image
Page
34
EXAMPLE To program a pause of 6 seconds, press:
To delete pause, follow steps a through d above, entering “0” at step c.
After programming has been completed, watering will begin automatically at the
next scheduled start time (beginning of loop). To activate the loop cycle prior to
then, follow the instructions below.
MANUALLY STARTING LOOP CYCLE
To activate a loop cycle at other than its scheduled start time (beginning of loop),
do the following:
a. Turn the dial to desired program.
b. Key in the first station intended to turn on.
c. Press Manual On/Off key. (Display will alternately flash station
number and remaining water time.)
d. Return dial to Auto position.
Note: If loop cycle is manually started, it will continue until its programmed end
time (end of loop) unless it is manually stopped before then.
Manually Stopping Loop Cycle: With dial at program in operation, press Man-
ual On/Off key.
0
6
FRI
ENTER
STA
WATER
TIME

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the SUPERIOR CONTROLS STERLING CONTROLLERS and is the answer not in the manual?

SUPERIOR CONTROLS STERLING CONTROLLERS Specifications

General IconGeneral
BrandSUPERIOR CONTROLS
ModelSTERLING CONTROLLERS
CategoryController
LanguageEnglish