Page
16
Activating One Station To Water For Its
Programmed Duration
To activate station:
a. Turn dial to program in which station is included.
b. Key in station number.
c. Press Stn. Water Time key.
d. Press Manual On/Off key.
e. Return dial to Auto position.
After watering, controller will not advance to the next programmed watering
station.
Activating A Watering Cycle
To activate the watering cycle of a program at a time other than its scheduled
start time(s), do the following:
a. Turn the dial to desired program.
b. Key in the first station intended to turn on.
c. Press Manual On/Off key (Display will alternately flash station number
and remaining water time.)
d. Return dial to Auto position.
Activating A System Check Cycle
This feature activates a watering cycle for a walk-thru check of the irrigation sys-
tem. The controller will advance through all stations in sequence beginning with
the station chosen to initiate the cycle. Station run time (same for all stations) is
programmable from 1 to 15 minutes.
To initiate watering at Station 1:
a. Turn the dial to System Check position.
b. Key in station run time (1 to 15).
c. Press Manual On/Off key.
d. Return the dial to Auto position.
To initiate watering at a station other than # 1:
a. Turn the dial to System Check position.
b. Key in station run time (1 to 15).
To Next Page
Loading...
Need help?
General