Page
13
5. Set Cycle Start Time(s): The cycle start time is the time of day a program
will begin watering. For each cycle start time that is set (up to 9), all stations as-
signed to the program will water in sequence beginning with the lowest num-
bered station. To set the time a program will begin watering:
a. Key in the cycle number (1= cycle start 1, 2 = cycle start 2, etc.)
b. Press Cycle Start key.
c. Key in time of day that cycle is to start.
d. If cycle start is during p.m. period, press the PM/% key
e. Press Enter key.
f. Follow the same procedure for each additional cycle start. Up to 9 cycle
start times may be scheduled in each program.
EXAMPLE: Controller is to initiate two watering cycles on the scheduled
watering days. The first cycle is to start at 6:15 a.m.; second cycle to start
at 2:00 p.m., press:
To change a cycle start time, follow steps a through e above entering the new
time at step c. To delete a cycle start, enter “0” at step c.
Do not schedule a watering cycle to start prior to completion of the previous
cycle within the same program. The controller will ignore the subsequent over-
lapping cycle. To determine the end time of a cycle, key in the cycle number (1=
cycle start 1, 2= cycle start 2, etc.), then press the Cycle Start key twice.
To scroll through the start and stop times of all scheduled cycle starts, press the
Clear key, then the Cycle Start key.
CYCLE
START
1
SUN
6
FRI
1
SUN
5
THU
ENTER
CYCLE
START
2
mon
2
mon
0 0
PM
%
ENTER
To Next Page
Loading...
Need help?
General