5
THU
0 0 0 PM
%
ENTER
CYCLE
START
CYCLE
START
9 9 0 0
ENTER
Page
23
To set the time that watering will start (beginning of loop), turn dial to desired
program.
a. Press 9 key.
b. Press Cycle Start key.
c. Key in the time of day that watering is to start. If during p.m., the next step
is to press the PM/% Key.
d. Press Enter key.
To program the time that watering will stop (end of loop):
a. Press 0 key.
b. Press Cycle Start key.
c. Key in time of day watering is to end. If during p.m., the next step is to press
the PM/% key.
d. Press Enter key.
EXAMPLE: To program a loop beginning at 9:00 a.m. and continuing until 5:00
p.m., press the following keys to program beginning of loop:
Press the following keys to program end of loop:
To change the beginning of the loop and/or the end of the loop, repeat either
or both of steps a thru d above, entering the new time at step c. To delete the
loop, enter 0 at step c for both the beginning and end times.
Delay:
To schedule a delay between cycles:
a. Key in number 90.
b. Press Stn. Water Time key
c. Key in delay time (1 minute to 4 hours, 15 minutes).
Note: The delay time is the period between the end of one cycle and the start
of the next.
d. Press Enter key.
To Next Page
Loading...
Need help?
General