Page
9
•
•
•
•
•
•
•
•
•
Percentage function to simultaneously increase or decrease the station
water time of all stations within a program.
Programmable Rain Off up to 14 days. The controller will resume auto-
matic operation on the day following the last programmed “Off" day.
Sensor feature that allows Program 6 to be activated by a “normally open"
sensor switch such as a thermostat. Optional Frost Override feature dis-
ables programs 1 thru 5 during operation of Program 6.
Loop watering in which a program’s watering cycle is continuously re-
peated for a desired period. Cycles can repeat immediately or after a pro-
grammable delay of 1 min. to 4 hours, 15 min.
Program-erase feature that allows existing programs to be erased individ-
ually or all at once.
For simplified program review, the following information can be scrolled
on the display: 1) watering duration of each station, 2) watering days, 3)
skip days, 4) cycle start/stop times, and 5) status of options (“On” or
“Of ”).
Single entry procedure for entering the same watering time in a block of
consecutive stations.
Master valve/pump start circuit can be disabled during operation of any
program.
Manual valve/pump start station can be turned on manually without an-
other station turning on.
To Next Page
Loading...
Need help?
General