SUPERBRUSH SPECIFICATIONS 27
SUPERBRUSH SPECIFICATIONS
SUPERBRUSH 24 SUPERBRUSH 36
Warranty: Two years on parts and labor, limited;
Manufacturer’s warranties on conveyor belts and brush heads.
Dimensions: Model 24: Height: 52˝ Width: 46˝; Depth: 42˝
Model 36: Height: 52˝ Width: 58˝; Depth: 42˝
Dust Hood: Model 24: Steel hood with 4˝ vacuum port, hinged back
Model 36: Steel hood with two 4˝ vacuum ports, hinged back
Brush Speed: Infinitely Variable, 400-1200 RPM.
Brush: See Brushes & Supplies, page 35
Bearings: 1˝ sealed, permanently lubricated, ball.
Conveyor Bed: Steel reinforced with four steel cross sections.
Conveyor Motor: 100 in-lbs. torque, direct-drive
DC motor (1/17 HP).
Infinitely variable from 0 to 15 feet per minute.
Conveyor Belt: Polyurethane, roughtop surface belt, with monofilament
back, included. (Optional abrasive belt available.)
Stand Zinc-plated steel, cast aluminum. Column tubes are
Construction: centerless ground.
Drive Motor: Both Models: 5HP, TEFC; 1,725 RPM; 60 HZ. Continuous Duty
Single phase 208-230V; Optional three phase: 230V or (460V three phase)
Minimum Stock All Models 10˝ without fixtures.
Length:
Height All Models: 3/32˝ per turn; Depth Gauge with locking stop included.
Adjustment:
Stock Thickness 11˝ maximum, typical* with nylon brushes.
Capacity: 12” maximum, typical* with wire brushes.
*can vary depending on specific brush types
Approximate Model 24: 375 lbs.
Shipping Weight: Model 36: 475 lbs.
Tension Rollers: 1 1/2˝ diameter, rubber covered infeed and outfeed rollers
mounted under spring tension, fully adjustable.
Dust Collection: Mandatory for all models.
To Next Page
Loading...
