User manual [English]
18
“Symbol Rate” for this new transponder. The
parameters of “TP Frequency” and “Symbol
Rate” can set by number keys. The available
range are “3000~13450 MHz” and
“1000~45000Ks/s”.
When you press[[yellow] key, there will show
up a warning message for reminding whether
you will delete the current transponder or not.
If you select “Yes”, the current transponder
will be deleted, and the total account of
transponder will reduce 1 correspondingly.
3 For the existed transponder, you also can
use number keys to modify the parameters of
“TP Frequency” and “Symbol Rate” or
press[Volume Up/ Volume Down]key to
switch it directly.
4 “Polarity” and “Scan Mode” are use for
setting scans conditions, you can
press[Volume Up/ Volume Down]key to
select different mode. “Polarity” means you
want to scan this TP in horizontal mode or in
vertical mode. “Scan Mode” means you want
to scan all channels or only scan free
channels.
5 When you complete your modification, move
highlight to “Search” item and press [OK]key,
it will show up a dialog to ask you scan
mode, program type,Scan Type and NIT
Search on/off. After you set up, press [OK]
key to start scanning.
! Notice
When you choose Scan Type with "Auto
Scan", you can not modify NIT Search.
6 In the “TP Scan” item, press [Exit] key to exit
the scanning and save the current
parameters.
8.1.10 Single Search
1 Press [Left/Right] key to select search mode.
Quick means preset scan, that is searching
the existed TP. Detail means blind scan. It is
no need existed TP info.
2 Press [OK] key, it will show up a dialog to ask
you scan mode, program type,Scan Type
and NIT Search on/off. After you set up,
press [OK] key to start scanning.
8.1.11 Multi Search
1 Multi Search can support search the multi
satellite one by one as user select.
2 Press [Left/Right] key to select search
mode. Quick means preset scan, that is
searching the existed TP. Detail means blind
scan. It is no need existed TP info.
3 Press [OK] key, it will show up a dialog to
ask you scan mode, program type,Scan
Type and NIT Search on/off. After you set
up, press [OK] key to start scanning.
8.1.12 Auto DiSEqC
Press [Blue] key to run Auto DiSEqC function,
it can find the satellite connect to which port
automatically.
8.1.13 AUTO Scan
Press [White] key can directly into auto scan
mode to scan the current satellite.
8.2 CA Setting (Optional)
Depending on your receiver version, we provide
one CA slot for user to use. Receiver has build
in smart card module with CONAX system. By
using cards in this system provided by
operators, it is possible to watch many
scrambled channels coded in this system. This
menu shows detailed information about card
inserted into card reader module. It allows
inserted according to help messages visible on
the bottom of the screen.
To Next Page
Loading...