SuperMax TV - Parental Lock

User manual [English]
23
1 Subtitle Display: You can press [Volume
Up/Volume Down] key to selectstandard ,
teletext subtitle” or “Off”. If the current
channel has subtitle information, it will be
showed up while this function is “standard or
teletext subtitle”. If this function is “Off”, there
won’t show up subtitle information even if the
current channel has subtitle information.
2 OSD Timeout: When you switch channels in
full screen, there will show up some
information about current channel on the
lower of the screen. And regarding to the
duration of these information show up on the
screen, you can press [Volume Up/Volume
Down] key to set the time. The range of the
duration is “1 second ~ 10seconds”.
3 Position: control display position of the info
bar in full screen mode. You can choose
“bottom” or “top”.
4 OSD Transparency: Besides the setting of
“OSD Menu Style”, you also can set the
transparency of OSD. You can press
[Volume Up/Volume Down] key to select the
values. There are 5 levels of transparency,
10%, 20%, 30%, and 40% and “NO” (means
no transparency function).
5 Load OSD Setting Default: If you are not
satisfy with your setting, you can move
highlight to this item and press [OK] key to
reset parameters as default value.
6 Panel Power In Standby:if set to “ON”, the
front panel will display time or some other
information in standby mode; if set to “OFF”,
it will display nothing in standby mode.(Note:
this function only available when the “Deep
Standby” item is set to “ON”)
7 PIP Function:You can press [Left/Right] keys
to switch PIP Function “On/Off”.
8 Deep Standby: You can press left or right key
to select “ON” or "Off” enable or disable
Deep Standby function, if enable Deep
Standby function the consumption will less
than 1 Watt.(Note: the “Panel Power In
Standby” item need set to “OFF”)
9 Press [Menu] key to draw back from the
“OSD Setting” menu.
9.8 Parental Lock
You can set a password for anyone who wishes
to operate in the main menu. And you can also
set the password for the lock channels. (How to
set the lock channel please refer to LOCK) Here
will show you how to setting and how to revising
the password.
1 In “Parental Lock” function, press [OK] key,
there will pop an dialogue for you to input the
password. When you input the correct
password, you will see a screen like belo
w:
2
Menu Lock determining that when user wish
to enter main menu, whether have to input