SUPER P4DC6/P4DC6+/P4DC6+II/P4DCE/P4DCE+/P4DCE+II User’s Manual
A-4
FLOPPY DISK(S) fail (80)
→ Unable to reset floppy subsystem.
FLOPPY DISK(S) fail (40) → Floppy Type dismatch.
Hard Disk(s) fail (80)
→ HDD reset failed
Hard Disk(s) fail (40) → HDD controller diagnostics failed.
Hard Disk(s) fail (20)
→ HDD initialization error.
Hard Disk(s) fail (10)
→ Unable to recalibrate fixed disk.
Hard Disk(s) fail (08)
→ Sector Verify failed.
Keyboard is locked out - Unlock the key.
BIOS detect the keyboard is locked. P17 of the keyboard controller is pulled low.
Keyboard error or no keyboard present.
Cannot initialize the keyboard. Make sure that the keyboard is attached correctly and no
keys are being pressed during the boot.
Manufacturing POST loop.
System will repeat POST procedure infinitely while the P15 of keyboard controller is pulled
low. This is also used for M/B burn in testing.
BIOS ROM checksum error - System halted.
The checksum of ROM address F0000H-FFFFFH is bad.
Memory test fail..
BIOS reports the a memory test fail if the onboard memory has an error.
To Next Page
Loading...
Need help?
General
