SureTouch Refrigerated Liquid Dispensers • SureShot Technical Assistance Center: 1-888-777-9990 or 902-865-9602
10
SIDE CONSOLE FUNCTIONS
SureTouch Liquid Dispensers are equipped with a side console which displays
continuous or touch-of-a-button refrigeration temperature and allows temperature
adjustment. The side console is located on the lower left side toward the front of the
dispenser.
Each SureTouch dispenser’s temperature is pre-set for normal use in the North American
food service industry. The temperature is set to maintain the product within the range of
32 ºF/0 ºC to 40 ºF/4.4 ºC. These settings should not require adjustment.
Blue/Top Temperature Adjust
Button – Decreases the
temperature
Temperature Display Window
Infrared Programming Window
Red/Bottom Temperature Adjust
Button – Increases the
temperature; Changes the Display
Mode between d1 and d2
The side console operates in two different modes:
Selective Display Mode
Temporarily displays the current temperature in the product compartment in ºF with a
single temperature adjust button press.
Adjustments cannot be made in Selective Mode.
Dispensers are shipped from our factory in Selective Mode.
To Enter Selective Display Mode from Continuous Display Mode:
1. Press and hold the Red/bottom temperature adjust button for approximately three (3)
seconds until a beep is heard.
2. d2 will display for three (3) seconds and then the Temperature Display Window will
be blank confirming Selective Display Mode is active.
This mode locks out any further adjustments to the refrigeration setting.
Continuous Display Mode
Displays the current temperature in the product compartment in ºF and displays current
function while adjustments are being performed.
To Enter Continuous Display Mode from Selective Mode:
1. Press and hold the Red/bottom temperature adjust button for approximately three (3)
seconds until a beep is heard.
2. d1 will display for three (3) seconds and temperature will remain on the Temperature
Display Window confirming Continuous Display Mode is active.