SureTouch Refrigerated Liquid Dispensers • SureShot Technical Assistance Center: 1-888-777-9990 or 902-865-9602
17
Condenser
1. Turn the power to the dispenser OFF.
2. Unplug the dispenser.
3. Remove back panel by removing the screws that secure it in
place. Carefully remove the back panel.
4. Gently clean the condenser using a vacuum with soft brush
attachment. A vacuum is recommended to prevent damage to
the condenser coil.
5. Replace back panel. Reinstall screws to secure the back
panel in place.
6. Plug the dispenser in.
7. Turn the dispenser ON.
Fan and Inner Body
1. Turn the power to the dispenser OFF.
2. Unplug the dispenser.
3. Remove back panel by removing the four (4) screws that
secure it in place. Carefully remove the panel.
4. Gently clean the fan and inner body using a vacuum with soft brush attachment. A
vacuum is recommended to prevent damage to the fan.
5. Wipe fan and inner body as required with a soft cloth slightly dampened with warm,
clean, soapy water.
Note: Do not get the circuit boards or wires wet.
6. Dry thoroughly with a soft cloth.
7. Ensure all foreign objects (cloths, etc.) are removed from the inner body of the
dispenser.
8. Plug in the dispenser.
9. Turn the dispenser ON.
10. Check that the fan is spinning smoothly and unobstructed. Do a visual inspection
only. To avoid injury or equipment damage, keep hands and objects clear of the fan
when the equipment is plugged in.
11. Replace back panel. Reinstall screws to secure the panel in place.
Backlit Advertising Display (Optional)
Removal and Installation
1. Remove the two screws on the
side of the outer shell of the door
assembly.
2. Gently swing door open to reveal
the reverse side of the backlit
transparency
3. Remove the transparency using
your finger in the notch at the top
corners of the display.
4. Gently remove one side by
slightly bending the transparency
to release from sliders.
5. Install or replace with new
transparency and repeat steps in
reverse order, taking care not to
pinch cable next to hinge.