Suzuki AN400 - Page 126

6B-1 Steering / Handlebar:
Steer ing
Steering / Handlebar
Schematic and Routing Diagram
Grip Heater Wiring Diagram (AN400ZAK9)
B905H16202001
4
1
1
2
2
“B”
“C”
“A”
3
5
6
FWD
UP
“D”
I905H1620001-02
1. Grip heater (RH) 6. Clamp
: Bind the grip heater lead wire (LH) and grip heater switch
lead wire with the clamp. Cut off the excess end of clamp.
2. Grip heater (LH) “A”: Clamp the grip heater lead wire in a position so that it may not
be pulled taut when the throttle grip is operated.
3. Clamp
: Bind the grip heater lead wire (RH) and handlebar switch lead wire (RH)
with the clamp. Cut off the excess end of clamp.
“B”: Align the master cylinder holder’s mating surface with the
white taping point of lead wire.
4. Clamp
: Bind the grip heater lead wire (RH) with the clamp. Cut off the excess end
of clamp.
“C”: Do not pinch the lead wire between the handlebar covers.
Clamp the lead wire between the handlebar switch and brake
lever holder.
5. Clamp
: Bind the grip heater lead wire (LH), grip heater switch lead wire and
handlebar switch lead wire (LH) with the clamp. Cut off the excess end of
clamp.
“D”: Secure the clamp so that the grip heater lead wire may not be
tensioned or excessively loose.