Suzuki AN400 - Page 127

Steering / Handlebar: 6B-2
Repair Instructions
Grip Heater Removal and Installation (AN400ZAK9)
B905H16206016
Removal
Refer to “Grip Heater Removal and Installation (AN400ZK7/K8)” in related manual.
Grip Heater Diagram
Installation
Refer to “Grip Heater Removal and Installation (AN400ZK7/K8)” in related manual.
Grip Heater Inspection (AN400ZAK9)
B905H16206017
1) Disconnect the grip heater lead wire couplers. Refer
to “Grip Heater Removal and Installation
(AN400ZK7/K8)” in related manual.
2) Measure the grip heater resistance between the lead
wires. If the resistance is not within the specified
value, replace the grip heater with a new one.
Special tool
: 09900–25008 (Multi circuit tester set)
Tester knob indication
Resistance (Ω)
Grip heater resistance
LH: 4.50 – 5.50 Ω at 20°C (68°F) (B – B)
RH: 3.78 – 4.62 Ω at 20°C (68°F) (B – B)
G/BO
B BB B
W/B
RG/B
G/B R
O/YW/B
OO/Y
W/B
I905H1620002-01
I905H1620003-01