Suzuki AN400 - Page 134

9A-4 Wiring Systems:
Wiring Routing Diagram (AN400A/ZAK9)
B905H19102006
“C”
4
3
1
“D”
[A]
2
“A”
“B”
“a” “a”
I905H1910903-07
1. Clamp
: Bind the handlebar switch lead wire (RH) and grip heater lead wire
(RH) [AN400ZA only] with the clamp. Cut off the excess end of clamp.
“B”: Pass the handlebar switch lead wires (LH & RH) outside of the throttle
cables.
2. Clamp
: Bind the handlebar switch lead wire (LH), grip heater switch lead
wire [AN400ZA only] and grip heater lead wire (LH) [AN400ZA only]
with the clamp. Cut off the excess end of clamp.
“C”: Align the master cylinder holder’s mating surface with the white taping
point of lead wire.
3. Clamp
: Bind the grip heater lead wire (RH) with the clamp.
Cut off the excess end of clamp.
“D”: Pass the parking brake switch lead wire over the cushion.
4. Clamp
: Bind the grip heater lead wire (LH) and grip heater switch lead wire
with the clamp.
Cut off the excess end of clamp.
[A]: AN400ZA
“A”: Clamp the lead wires at red taping point. “a”: 15 – 25 mm (0.6 – 1.0 in)