Wiring Systems: 9A-5
“A”
“B”
“A”
13
“A”
1
2
3
5
4
7
6
8
9
12
10
“C”
“A”
“D”
“E”
“F”
11
“G”
FWD
“A”
15 14
I905H1910904-03
1. Frame 12. Clamp
: Bind the wiring harness and battery (–) lead wire with the clamp.
2. Parking brake cable 13. Clamp
: Bind the regulator/rectifier lead wire and battery lead wires ((+) & (–)).
3. Starter motor lead wire 14. Clamp
: Bind the wiring harness and battery (+) lead wire with the clamp.
4. Brake hose 15. Clamp
: Bind the wiring harness, headlight branch wire and battery (+) lead
wire with clamp.
5. Seat lock cable “A”: White tape
6. Clamp
: Bind the brake hose, parking brake cable and starter motor lead wire
with the clamp.
Do not contact the tip of clamp with the air cleaner box. The tip of
clamp should face outside of the motorcycle.
“B”: Pass the wiring harness in front of the seat lock cable.
7. Clamp
: Bind the starter motor lead wire and parking brake cable with the
clamp.
“C”: Do not pinch the lead wire and wiring harness between front leg shield
and brace.
8. Clamp
: Bind the starter motor lead wire and wiring harness with the clamp.
“D”: Black tape
9. Clamp
: Bind the wiring harness with the clamp.
“E”: Blue tape
10. Clamp
: Bind the handlebar switch lead wires (LH & RH), grip heater lead
wires (LH & RH) [AN400ZA only] and grip heater switch lead wire
[AN400ZA only] with the clamp.
“F”: Green tape
11. Clamp
: Bind the starter motor lead wire, battery (+) lead wire, wiring harness
and dealer mode coupler lead wire with the clamp.
“G”: Set the handlebar switch couplers (LH & RH) behind the main harness.
To Next Page
Loading...
