9A-6 Wiring Systems:
4
7
2
3
5
6
1
“J”
14
16
“I”
13
11
12
“G”
15
“K”
“B”
“L”
10
9
10
“F”
“D”
8
“A”
“B”
“E”
“C”
“H”
FWD
I905H1910905-03
1. IAT sensor 15. High-tension cord
2. STVA 16. Clamp
: The tip of clamp should face right side of the motorcycle.
3. STP sensor “A”: Pass the ignition coil lead wire inside of the water by-pass hose.
4. TP sensor “B”: To IAT sensor
5. ISC valve “C”: Position the couplers at the center between the clamps.
6. IAP sensor “D”: White tape (Generator lead wire)
7. Fuel injector “E”: Do not make slacked part.
8. Ignition coil “F”: Pass the lead wires and wiring harness over the wiring harness
stopper.
9. Clamp
: Bind the generator lead wire and HO2 sensor lead wire with the
clamp.
“G”: To rear combination light
10. Wiring harness stopper “H”: Pass the wiring harness in front of the frame.
11. Clamp
: Bind the speed sensor lead wire and rear wheel speed sensor lead
wire with the clamp.
“I”: Pass the lead wire outside of the hoses.
12. Clamp
: Bind the wiring harness, speed sensor lead wire, generator lead wire
and rear wheel speed sensor lead wire with the clamp.
“J”: Pass the horn lead wire behind the bracket.
13. Clamp
: Bind the wiring harness, battery (–) lead wire and side-stand switch
lead wire with the clamp.
“K”: To main harness
14. Clamp
: Bind the throttle cables (No. 1 & No. 2), wiring harness and battery (–
) lead wire with the clamp.
“L”: To license light
To Next Page
Loading...
