Suzuki AN400 - Page 39

Brake Control System and Diagnosis: 4A-1
Brake
Brake Control System and Diagnosis
Schematic and Routing Diagram
Front Brake Hose Routing Diagram (AN400A/ZAK9)
B905H14102003
1
5
6
7
3
6
10
1
5
9
3
10
“B”
“A”
3
10
11
9
4
3
5
6
2
2
(a)
(a)
(a)
(a)
(b)
8
(b)
I905H1410001-02
1. ABS control unit/HU 9. Rear brake pipe No. 2
2. Rubber 10. Front brake hose No. 2
3. Stopper
: After the brake hose union has contacted the stopper, tighten the
union bolt.
11. Clamp
: Insert the brake hose clamp to the hole of front fender properly.
4. Stopper
: After the brake pipe protector has contacted the stopper, tighten the
brake pipe flare nut.
“A”: Fix the brake hose protector to its hose clamp.
5. Rear brake hose No. 1 “B”: After the clamp has contacted the stopper, tighten the clamp mounting
bolt.
6. Front brake hose No. 1 : 23 N⋅m (2.3 kgf-m, 16.5 lbf-ft)
7. Brake hose guide : 16 N⋅m (1.6 kgf-m, 11.5 lbf-ft)
8. Stopper
: After the brake hose union has contacted the stopper, tighten the
union mounting bolt.