ENGINE 3-59
• Remove the washer
1.
• Remove the top driven gear
2 by removing the snap ring.
" 09900-06107: Snap ring pliers
• Remove the snap ring with the special tool.
" 09900-06107: Snap ring pliers
• Remove the 2nd driven gear
3, its bushing
4 and washer
5.
REASSEMBLY
Assemble the transfer in the reverse order of disassembly. Pay
attention to the following points:
NOTE:
* Always use new snap rings.
* Before installing the gears, coat lightly engine oil to the shafts
and gears.
#
* Never reuse a snap ring. After a snap ring has been
removed from a shaft, it should be discarded and a
new snap ring must be installed.
* When installing a new snap ring, care must be taken
not to expand the end gap larger than required to slip
the snap ring over the shaft.
* After installing a snap ring, always ensure that it is
completely seated in its groove and securely fitted.
To Next Page
Loading...
