Suzuki DL1000 - Page 116

3-70 ENGINE
• Remove the oil seal.
#
• Remove the oil seal with the special tool.
" 09913-50121: Oil seal remover
#
• Remove the bearing retainers.
• Remove the bearings with the special tool.
" 09921-20240: Bearing remover set
NOTE:
If there is no abnormal noise, the bearing removal is not neces-
sary.
• Install the bearings with the special tool.
" 09913-70210: Bearing installer set
NOTE:
The sealed side of the driveshaft bearing must face outside.
The removed oil seal must be replaced with a new one.
The removed oil seal must be replaced with a new one.