ENGINE 3-73
• Gradually press out the bearing with the special tool by using
the hand-press.
#
NOTE:
Using the hand-press is recommended to remove the crankshaft
journal bearings. However, the crankshaft journal bearings can
be removed by using with the following special tools.
" 09924-84510: Bearing installer set
09924-74570: Final drive gear bearing
remover/installer
• Set the specified crankshaft journal bearings to the special
tool.
#
" 09913-60210: Journal bearing remover/installer set or
09913-60240: Journal bearing remover/installer
NOTE:
Journal bearing remover/installer (09913-60240) is included in
Journal bearing remover/installer set (09913-60210).
The removed bearings must be replaced with new
ones.
Hand-press
Crankcase
Bearing
Bearing
* Before setting the bearing, apply enough engine oil
to the special tool and bearings.
* When setting the bearing, align the bearing side with
the engraved line
A and also the bearing edge with
the mating surface of the special tool.
09913-60210
09913-60240
To Next Page
Loading...
