ENGINE 3-75
• Apply enough engine oil to the special tool and the bearings
and then set the special tool carefully.
• Gradually press in the bearing into the main journal bore by
using the hand-press until the special tool
1 stops the special
tool
2.
" 09913-60230: Journal bearing remover/installer
#
NOTE:
Using the hand-press is recommended to install the crankshaft
journal bearings. However, the crankshaft journal bearings can
be installed by using the following special tools.
" 09924-84510: Bearing installer set
09924-74570: Final drive gear bearing
remover/installer
Hand-press
Bearing
Bearing
Use the new special tool
A (09913-60230) for DL1000.
The tool
A and
B differ in length
C.
For DL1000
(09913-60230)
For TL1000S/R
(09913-60210)
To Next Page
Loading...
