ENGINE 3-101
_
NOTE:
When checking the cam drive idle gear/sprocket
1 position at
its gear tooth, top or root, bring the eye level as shown in right
illustration.
• Tighten the cam drive idle gear/sprocket shaft to the specified
torque.
$ Cam drive idle gear/sprocket shaft:
40 N·m (4.0 kgf-m, 29.0 lb-ft)
CAM CHAIN TENSION ADJUSTER
• Install the front cam chain tension adjuster to the following
procedure.
NOTE:
The cam chain tension adjusters are distinguished by the
shapes.
1 For No.1 (Front) cylinder
2 For No.2 (Rear) cylinder
• Turn in the cam chain tension adjuster bolt
3 fully.
6˚
To Next Page
Loading...
