3-104 ENGINE
REAR CAM CHAIN TENSION ADJUSTER
• Install the rear cam chain tension adjuster to the following pro-
cedure.
• Disassemble the rear cam chain tension adjuster.
• Compress the cam chain tension adjuster rod by releasing the
ratchet.
• Install the new gasket
1.
#
• Install the cam chain tension adjuster as shown and tighten its
mounting bolts to the specified torque.
$ Cam chain tension adjuster mounting bolt:
10 N·m (1.0 kgf-m, 7.0 lb-ft)
• Install a new O-ring, spring and cam chain tension adjuster
bolts and tighten them to the specified torque.
NOTE:
Apply grease to the O-ring before installing.
' 99000-25030: SUZUKI SUPER GREASE ‘‘A’’ (USA)
99000-25010: SUZUKI SUPER GREASE ‘‘A’’ (Others)
$ Cam chain tension adjuster bolt (Rear):
7 N·m (0.7 kgf-m, 5.0 lb-ft)
NOTE:
Click sound is heard when extending the cam chain tension
adjuster rod.
#
Use the new gasket to prevent oil leakage.
After installing the cam chain tension adjuster, check
to be sure that the adjuster work properly by checking
the slack of cam chain.
To Next Page
Loading...
