Suzuki DL1000 - Page 297

6-40 CHASSIS
DUST SEAL
• Install the new dust seal using the special tool.
# 09913-70210: Bearing installer set
• Apply SUZUKI SUPER GREASE “A” to the dust seal lips
before assembling rear wheel.
% 99000-25030: SUZUKI SUPER GREASE “A” (USA)
99000-25010: SUZUKI SUPER GREASE “A” (Others)
NOTE:
When installing the dust seals, the stamped mark of dust seal
must face the special tool.
BRAKE DISC
Make sure that the brake disc is clean and free of any greasy
matter.
• Apply THREAD LOCK SUPER “1360” to the disc bolts and
tighten them to the specified torque.
' 99000-32130: THREAD LOCK SUPER “1360”
& Brake disc bolt: 23 N·m (2.3 kgf-m, 16.5 lb-ft)
REAR SPROCKET
• Tighten the sprocket mounting nuts to the specified torque.
& Rear sprocket nut: 60 N·m (6.0 kgf-m, 43.5 lb-ft)
NOTE:
Stamped mark
A on the sprocket must face outside.
• Apply SUZUKI SUPER GREASE “A” to the rear sprocket
mounting retainer.
• Install the rear sprocket mounting drum retainer.
• Apply SUZUKI SUPER GREASE “A” to the contacting surface
between the rear wheel and the sprocket drum.
% 99000-25030: SUZUKI SUPER GREASE “A” (USA)
99000-25010: SUZUKI SUPER GREASE “A” (Others)