CHASSIS 6-65
• When remounting the brake master cylinder onto the handle-
bars, align the master cylinder holder’s mating surface
A with
punch mark
B on the handlebars and tighten the upper clamp
bolt first as shown.
& Front brake master cylinder mounting bolt:
10 N·m (1.0 kgf-m, 7.0 lb-ft)
• Tighten the union bolt. (Brake hose routing: !8-24)
& Brake hose union bolt: 23 N·m (2.3 kgf-m, 16.5 lb-ft)
"
* The seal washers should be replaced with the new
ones to prevent fluid leakage.
* Bleed air from the system after reassembling the
master cylinder. (!2-24)
To Next Page
Loading...
