74 A-96.250.571 / 050517
AMI Codes-II
Program Overview
Sample Flow Flow Alarm 5.3.1.3.1*
5.3.1.3* Alarm High 5.3.1.3.x*
Alarm Low 5.3.1.3.x*
Sample Temp. Alarm High 5.3.1.4.1*
5.3.1.4* Alarm Low 5.3.1.4.x*
Case Temp. high 5.3.1.5*
Case Temp. low 5.3.1.6*
Relay 1&2 Function 5.3.2.1 & 5.3.3.1*
5.3.2* & 5.3.3* Parameter 5.3.2.x & 5.3.3.x*
Setpoint 5.3.2.x & 5.3.3.x*
Hysteresis 5.3.2.x & 5.3.3.x*
Delay 5.3.2.x & 5.3.3.x*
Input Active 5.3.4.1*
5.3.4* Signal Outputs 5.3.4.2*
Output/Control 5.3.4.3*
Fault 5.3.4.4*
Delay 5.3.4.5*
Miscellaneous Language 5.4.1*
5.4* Set defaults 5.4.2*
Load Firmware 5.4.3*
Password Messages 5.4.4.1*
5.4.4* Maintenance 5.4.4.2*
Operation 5.4.4.3*
Installation 5.4.4.4*
Sample ID 5.4.5*
Line Break Detection 5.4.6*
Interface Protocol 5.5.1* (only with RS485
5.5* Device Address 5.5.21* interface)
Baud Rate 5.5.31*
Parity 5.5.41* * Menu numbers
To Next Page
Loading...
