Swann AMI Codes-II - Installation (Main Menu 5)

AMI Codes-II
Program Overview
A-96.250.571 / 050517 73
8.5. Installation (Main Menu 5)
4.2.1.2* Alarm Low 4.2.1.2.x*
Hysteresis 4.2.1.2.x*
Delay 4.2.1.2.x*
Relay 1& 2 Setpoint 4.2.x.x*
4.2.2* & 4.2.3* Hysteresis 4.2.x.x*
Delay 4.2.x.x*
Input Active 4.2.4.1*
4.2.4* Signal Outputs 4.2.4.2*
Output / Control 4.2.4.3*
Fault 4.2.4.4*
Delay 4.2.4.5*
Logger Log Interval 4.3.1*
4.3* Clear Logger 4.3.2* * Menu numbers
Sensors Disinf. 5.1.1* * Menu numbers
5.1* Dimension 5.1.2*
Interpolation 5.1.3*
Ref. Verification 5.1.4*
Standards Standard 1 5.1.50.1*
5.1.50* Standard 2 5.1.50.2*
Cleaning 5.1.6
Signal Outputs Signal Output 1&2 Parameter 5.2.1.1 & 5.2.2.1*
5.2* 5.2.1* & 5.2.2* Current Loop 5.2.1.2 & 5.2.2.2*
Function 5.2.1.3 & 5.2.2.3*
Scaling Range Low 5.2.x.40.x*
5.2.x.40 Range High 5.2.x.40.x*
Relay Contacts Alarm Relay Alarm DIS Alarm High 5.3.1.1.1*
5.3* 5.3.1* 5.3.1.1* Alarm Low 5.3.1.1.x*
Hysteresis 5.3.1.1.x*
Delay 5.3.1.1.x*
Alarm pH Alarm High 5.3.1.2.1*
5.3.1.2* Alarm Low 5.3.1.2.x*
Hysteresis 5.3.1.2.x*
Delay 5.3.1.2.x*