68 A-96.250.111 / 211019
AMI Trides
Program List and Explanations
2.2.2 Electrode (only available if option pH/Redox is installed):
Current value: Shows the current pH value.
Raw value: Shows the current voltage of the pH electrode in mV.
2.2.3 Miscellaneous:
2.2.3.1 Case Temp: Shows the current temperature in [°C] inside the trans-
mitter.
2.3 Sample
2.3.1 Sample ID: Shows the identification assigned to a sample. This
identification is defined by the user to identify the location of the
sample.
Temperature: Shows the current temperature in °C and NT5K in
Ohm.
Sample Flow: Shows the current sample flow in rotations per min-
ute (rpm)
2.4 I/O State
Shows current status of all in- and outputs.
2.4.1/2.4.2
2.5 Interface
Only available if optional interface is installed.
Review programmed communication settings.
Alarm Relay: Active or inactive
Relay 1 and 2: Active or inactive
Input: Open or closed
Signal Output 1 and 2: Actual current in mA
Signal Output 3: Actual current in mA (if option is installed)
To Next Page
Loading...