Swann AMI Trides - 11. Default Values; Default Values

AMI Trides
Default Values
A-96.250.111 / 211019 87
11. Default Values
Operation:
Sensors: Filter Time Const.: ..................................................................... 30 s
Hold after Cal.:......................................................................... 300 s
Default pH............................................................................ 7.00 pH
Relay Contacts Alarm Relay .................................................. same as in Installation
Relay 1/2...................................................... same as in Installation
Input.............................................................. same as in Installation
Logger: Logger Interval:..................................................................... 30 min
Clear Logger:................................................................................ no
Installation:
Sensors Type of Electrode:........................................................................ pH
pH Electrode..........................................................................without
Disinf............................................................................ Free chlorine
Dimension:................................................................................. ppm
Standards:
Standard 1 ........................................................................... 7.00 pH
Standard 2 ........................................................................... 9.00 pH
Signal Output 1 Parameter:.................................................................................. DIS
Current loop:..................................................................... 4 –20 mA
Function:.................................................................................. linear
Scaling: Range low:......................................................... 0.000 ppm
Scaling: Range high: ....................................................... 10.00 ppm
Signal Output 2 Parameter:.................................................................... Temperature
Current loop:..................................................................... 4 –20 mA
Function:.................................................................................. linear
Scaling: Range low:................................................................ 0.0 °C
Scaling: Range high: ............................................................ 50.0 °C
Alarm Relay: Alarm DIS:
Alarm high: ...................................................................... 10.00 ppm
Alarm low:........................................................................ 0.000 ppm
Hysteresis:......................................................................... 0.10 ppm
Delay: .......................................................................................... 5 s
Alarm pH:
Alarm high: ........................................................................ 14.00 pH
Alarm low:............................................................................ 0.00 pH
Hysteresis:........................................................................... 0.10 pH
Delay: .......................................................................................... 5 s