15- EN
WARNING AND SIGNAL LIGHTS
1) Left turn indicator light.
2) Right turn indicator light
3) High-beam light.
4) Neutral warning light.
5) Engine failure warning light.
6) Fuel reserve warning light.
7) Excessive coolant temperature indicator
8) ABS warning light
DIRECTION INDICATOR LIGHTS “ ”
The light flashes when activating the left or right hand turning indicator using
the control lever on the left-hand switch.
HIGH-BEAM LIGHT “ ”
The light comes on when activating the high-beam light using the control on
the left-hand switch.
NEUTRAL WARNING LIGHT“ ”
The light comes on when the gear shift lever is in neutral position (no gear
engaged).
ENGINE FAILURE WARNING LIGHT“ ”
When the ignition key is turned, the engine control unit runs a self-test, the
light comes on for a few seconds and then goes off if no fault is found.
If the light comes on while the engine is running, it means that there is an
engine or injection system failure.
-Stop and turn off the engine.
-Wait a few minutes and restart the engine; if the light comes on again, contact
your nearest SWM dealer to have the self-test system checked.
EXCESSIVE COOLANT TEMPERATURE INDICATOR. “ ”
The indicator lighting up warns that the engine overheated reaching an alarm
temperature.
-Stop and turn off the engine;
-Wait for the engine to cool down and then restart the engine.
If the problem occurs again, it is necessary to refer to the nearest SWM’s dealer
for a check.
To Next Page
Loading...
