EN-18
TRIP SETTINGS
Press the “Set” key (1) until “TRIP” appears and then press the button (1) for
more than 3 seconds to reset the value and return the count to 0 km or
miles.
UNIT OF MEASURE SETTINGS
The unit of measure must be set with the motorcycle stopped and key in the
ON position.
Press the “Set” key (1) until “ODO” appears and then press the button (1) for
more than 3 seconds to switch from km to miles or vice versa.
ERROR MESSAGES
In the event of a fault, the relevant error code is indicated on the display (1);
Find the nearest SWM dealer to check the fault.
Operate as shown for the following error codes.
To Next Page
Loading...
