EasyManuals Logo

Sym Citycom 300i Service Manual

Sym Citycom 300i
270 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #130 background imageLoading...
Page #130 background image
6
. Cylinder Head / Valve
6-13
After the valve seat ground, coat valve seat
surface with emery and then slightly press the
ground surface.
Clean up all emery coated onto cylinder and valve
after ground.
Cylinder Head Reassembly
Lubricate valve stem with engine oil, and then
insert the valve into valve guide.
Install new valve stem oil seal.
Install valve springs and retainers.
Caution
The closed coils of valve spring should face
down to combustion chamber.
Put the valve cotters onto valve spring retainer.
Use a valve cotter remove & assembly tool to
press the valve springs, and then install valves.
Caution
In order to avoid damaging the valve stem and
the cylinder head, in the combustion chamber
place a rag between the valve spring
remover/installer as compressing the valve
spring directly.
Special Service Tool:
Valve cotter remove & assembly tool
SYM-1471110-SY125
Tap the valve stems gently with a plastic hammer
to make sure valve retainer and valve cotter is
settled.
Caution
Place and hold cylinder head on to working
table so that can prevent from valve damaged.
Exhaust valve
Inlet valve
Valve stem seal
Valve spring
Valve spring retainer
Valve cotter
To this chapter contents
Valve cotter remove
and assembly tool

Table of Contents

Other manuals for Sym Citycom 300i

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Sym Citycom 300i and is the answer not in the manual?

Sym Citycom 300i Specifications

General IconGeneral
Engine Type4-stroke, Single Cylinder
Displacement278.3 cc
Fuel SystemElectronic Fuel Injection
Cooling SystemLiquid Cooled
Front SuspensionTelescopic Fork
Rear SuspensionDual Shock Absorbers
Front Tire110/70-16
Rear Tire140/70-16
Seat Height800 mm
TransmissionCVT
Front BrakeDisc
Rear BrakeDisc
Fuel Capacity10 liters

Related product manuals