Sym Citycom 300i - Engine Removal

5. Removal & Installation of Engine
5-2
Engine Removal
Open the seat.
Remove battery cover (3 screw).
Remove the battery negative (-) cable.
Remove the battery positive (+) cable.
Open the seat.
Remove the luggage box (6 bolts).
(Refer to chapter 13)
Remove right and left side covers (4 screws on
each side.)
Remove rear center cover(1 screw).
Remove rear carrier (4 bolts).
Remove right and left side garnish(1 screw).
Remove body cover (4 screws & 1 coupler & 2
bolts).
Remove floor panel(4 bolts).
(Refer to chapter 13)
Remove fuel injection system of electrical
couplers and fuel hoes
Remove idle speed control valve, MAP sensor,
injector couplers.
Positive
To this chapter contents
Negative
Idle speed control valve
MAP sensor coupler
Injector coupler