10. Alternator / Starting Clutch
10-7
Installation
Install the components in the reverse procedures
of removal.
Caution
z Add adhesive onto the thread of hex socket
bolt.
Torque value: 1.0~1.4kgf-m
Starting clutch Installation
Install idle gear shaft and idle gear.
Install starting clutch and the starting clutch.
Hold the starting driven gear with the universal
fixture.
Tighten the 22mm anti-loosen mounting nut and
gasket.
Caution
z Add engine oil onto the thread of mounting
nut.
Special service tools:
Anti-loosen mounting nut socket of starter
gear SYM-A12590201
Universal fixture SYM-2210100
Torque value: 9.0~10.0kgf-m
Right Crankcase Cover Installation
Install dowel pin and new gasket on the
crankcase.
Replace the right crankshaft oil seal of the
crankcase and apply some oil onto the oil seal lip.
Install right crankcase cover onto the right
crankcase (9 bolts)
Torque value: 1.5~2.0kgf-m
Spring
Roller
Plug
Clutch body
Clutch cover
9 bolts
To this chapter contents
To Next Page
Loading...
