Sym Mio 100 Service Manual

3. Lubrication System
3-3
Engine OIL
Turn off engine, and park the motorcycle in flat
surface with main stand.
Check oil level with oil dipstick
Do not screw the dipstick into engine as checking.
If oil level is nearly low level, fill out recommended
oil to upper level.
Oil Replacement
Caution
z Drain oil as engine warmed up so that make
sure oil can be drained smoothly and
completely.
Place an oil pan under the motorcycle, and
remove oil strainer cap.
Make sure if the aluminum washer of the draining
bolt is damaged. If so, replace it with new one.
Install the drain bolt and tighten it.
Torque value: 3.5~4.5kgf-m
Engine oil replacement quantity:
HU10U/W 650c.c.
HU05U 700c.c.
Draining bolt
To this chapter contents

Sym Mio 100 Specifications

General

Engine Type	4-stroke, Single Cylinder
Starting System	Electric & Kick
Transmission	CVT
Fuel System	Carburetor
Front Brake	Disc
Rear Brake	Drum
Tires Front	90/90-10
Tires Rear	90/90-10
Length	1760 mm
Height	1070 mm
Wheelbase	1230 mm
Fuel Tank Capacity	5.2 L