Sym Mio 100 - Page 35

2. Maintenance Information
2-12
ADDED BRAKE FLUID
Add brake fluid to UPPER limit lever.
Recommended brake fluid: DOT3 or DOT4 WELL
RUN brake fluid
Caution
z Never mix or use dirty brake fluid to prevent
from damage brake system or reducing brake
performance.
BRAKE LINING WEAR
The indent mark on brake lining is the wear
limitation.
Replace the brake lining if the wear limit mark
closed to the edge of brake disc.
Caution
z It is not necessary to remove brake hose
when replacing the brake lining.
Remove the brake clipper bolt, and take out the
clipper.
Caution
z Do not operate the brake lever after the
clipper removed to avoid clipping the brake
lining.
Pry out the brake lining with a flat driver if lining be
clipped.
Remove brake lining bolt.
Take out the lining
Caution
z In order to maintain brake power balance, the
brake lining must be replaced with one set.
Brake lining wear limit
Brake clipper
Brake disc
Brake
clipper
bolts
Pin bolts
Brake lining
Master cylinder cap
Upper limit
Brake fluid
To this chapter contents