3. Lubrication System
3-6
Oil Pump Inspection
Check the clearance between oil pump body and
outer rotor
Limit：below 0.12mm
Check clearance between inner and outer rotors.
Limit：below 0.12mm
Check clearance between rotor side face and
pump body
Limit：below 2.0 mm
Oil Pump Re-assembly
Install inner and outer rotors into the pump body
Align the indent on driving shaft with that of inner
rotor. Install the driving shaft
Install the oil pump cover and fixing pin properly
and then tighten screw. (1 screw)
To this chapter contents
To Next Page
Loading...
