1. GENERAL INFORMATION
1-16
Troubleshooting-EFi model
A. Engine cannot be started or difficult to be started
To this chapter contents
Check and adjustment Fault condition Probable causes
Normal cylinder compression pressure
Low or no compression
pressure
Restart the engine
No ignition With signs of ignition but
the engine cannot be
started
Remove and check the
spark plug
Dry spark plug Wet spark plug
1. Contaminated or clogged fuel injector
2. Malfunction of throttle valve operation
3. Malfunction of fuel pressure regulator
Press the fuel injector feed pipe and confirm
whether there is fuel in the feed pipe
The fuel supply to the fuel injector is
sufficient
The fuel injector is not
supplied with sufficient fuel
1. Check the fuel amount in the fuel tank
2. Check if the fuel pipe and the vacuum
tube are blocked or not
3. Malfunction of fuel pump relay or wiring
4. Malfunction of fuel pump
5. The fuel strainer is blocked or not
1. Piston ring seized
2. Malfunction of cylinder valves
3. Worn cylinder and piston ring
4. Cylinder gasket leakage
5. Sand hole in the com
ression
arts
1. Malfunction of throttle valve operation
2. Air sucked into intake manifold
3. Incorrect ignition timing
Check the spark plug ignition
condition
Perform cylinder compression
ressure test
Sparks
Week sparks or no spark
1. Malfunction of spark plug
2. Spark plug contamination
3. Malfunction of ECU
4. Malfunction of the AC Generator
5. Ignition coil is in open or short circuit
6. Malfunction of main switch
To Next Page
Loading...
Need help?
General
