1. GENERAL INFORMATION
1-19
E. CLUTCH AND DRIVING PULLEY
1. Broken clutch spring
2. Clutch outer stuck with clutch weights
3. Connection parts between clutch and shaft worn out or
burned
Engine can be started but the
vehicle cannot run
FAULT CONDITION PROBABLE CAUSES
1. Worn out or damaged drive belt
2. Damaged movable drive face
3. Damaged driven face spring
4. Broken clutch weight
5. Broken drive shaft groove
6. Worn out or damaged transmission gear
Engine shuts down or trembles
when the vehicle is running (rear
wheel rotates during engine idling).
Poor initial driving (poor climbing
performance)
1. Worn or deformed drive belt
2. Worn weight roller
3. Worn driven face
4. Deformed driven face spring
5. Grease on drive belt or drive / driven face
To this chapter contents
To Next Page
Loading...
Need help?
General
