Symantec ALTIRIS DEPLOYMENT SOLUTION 6.9 SP4 - V1.0 - Page 390

Deployment Solution 390
Command-Line Switches
VendorID Specifies the Vendor ID for the NIC.
Example: Vendor ID=32902.
DeviceID Specifies the device ID for the NIC.
Example: Device ID=4153.
PCIFunction Specifies the PCI Function for the NIC.
Example: PCI Function=0.
PCIDevice Specifies the PCI Device for the NIC.
Example: PCI device=8.
PCIBus Specifies the PCI Bus for the NIC.
Example: PCI Bus=1
WINS-Server1 Specifies the WINS Server 1 for TCP/IP.
Example: WINS-Server1=0.0.0.0.
WINS-Server0 Specifies the WINS Server 0 for TCP/IP.
Example: WINS-Server0=0.0.0.0.
WINS-Server-Count Specifies the number of WINS servers for TCP/IP.
Example: WINS-Server-Count=2.
WINS-Enabled Specifies whether the WINS servers are enabled.
Example: WINS-Enabled=True.
SetWINSInfo Specifies whether to set the WINS information.
Example: SetWINSInfo=True.
DNS-Server2 Specifies the DNS server 2 for TCP/IP.
Example: DNS-Server2=0.0.0.0.
DNS-Server1 Specifies the DNS server 1 for TCP/IP.
Example: DNS-Server1=0.0.0.0.
DNS-Server0 Specifies DNS server 0 for TCP/IP.
Example: DNS-Server0=0.0.0.0.
DNS-Server-Count Specifies the number of DNS Servers for TCP/IP.
Example: DNS-Server-Count=3.
DNS-Domain Specifies the DNS domain for TCP/IP.
Example: DNS-Domain=mydomain.com
DNS-Host Specifies the name of the DNS host.
Example: DNS-Host=TSTWXP2.
DNS-Enabled Specifies whether the DNS is enabled.
Example: DNS-Enabled=True.
SetDNSInfo Specifies the DNS information for TCP/IP.
Example: SetDNSInfo=True.
Parameters Details