Symantec ALTIRIS DEPLOYMENT SOLUTION 6.9 SP4 - V1.0 - Page 391

Deployment Solution 391
Command-Line Switches
Gateway Specifies the Gateway information for TCP/IP.
Example: Gateway=172.17.31.2.
Netmask Specifies the Netmask value for TCP/IP.
Example: Netmask=255.255.255.0.
Address Specifies the address for TCP/IP.
Example: Address=172.17.31.98.
DHCP Specifies the DHCP value for TCP/IP.
Example: DHCP=True.
SetIPInfo Specifies whether to set the IP information for TCP/IP.
Example: SetIPInfo=True.
NIC-Section-Count Specifies the NIC section count for TCP/IP.
Example: NIC-Section-Count=2.
Interface0
State Specifies the state of Interface0.
Example: State=Up.
Gateway Specifies the gateway of Interface0.
Example: Gateway=172.17.31.2.
Netmask Specifies the netmask of Interface0.
Example: Netmask=255.255.255.0.
IP-Address Specifies the IP address for Interface0.
Example: IP-Address=172.17.31.98.
DHCP Specifies the DHCP value for Interface0.
Example: DHCP=Yes.
Name This is the name of Interface0.
Example: Name=eth0.
Interface1
State Specifies the state of Interface1.
Example: State=Up.
Gateway Specifies the gateway of Interface1.
Example: Gateway=10.10.10.1.
Netmask Specifies the netmask of Interface1.
Example: Netmask=255.0.0.0.
IP-Address Specifies the IP-Address for Interface1.
Example: IP-Address=10.10.10.10.
NICEntry
Parameters Details