Symantec ALTIRIS DEPLOYMENT SOLUTION 6.9 SP4 - V1.0 - Page 397

Deployment Solution 397
Command-Line Switches
BlockedDaySat Specifies whether to block the client from connecting
to the Deployment Server between the times specified
in ScheduledBlockStart and ScheduledBlockEnd on
Saturdays.
Example: BlockedDaysSat=True.
Proxy
WakeOnLANProxy Forward Wake On LAN packets sent from the
Deployment Server.
Example: WakeOnLANProxy=Yes.
MCastProxy Specifies whether to advertise for the Deployment
Server the client is connected to. This allows local
clients to discover the server on a remote network
through TCP/IP multicast.
Example: MCastProxy=Yes.
MCastProxyRate Specifies how often to send multicast advertisements
in seconds. MCastPRoxy should be set to ‘Yes’ for this
setting to work.
Example: MCastProxyRate=900.
BootWorks
EnableDirectDiskAccess Specifies whether to enable direct disk access to
BootWorks.
Example: EnableDirectDiskAccess=Yes.
UpdateBootworkTransport Specifies whether to synchronize transport (IP/
multicast) settings with Bootworks.
EnableDirectDiskAccess must be enabled for this
setting to work.
Example: UpdateBootworkTransport=Yes.
UpdateBootworkIP Specifies whether to synchronize TCP/IP (static IP,
netmask/DHCP) settings with Bootworks.
EnableDirectDiskAccess must be enabled for this
setting to work.
Example: UpdateBootworkIP=Yes.
BootDiskMessageUsage Specifies when the user should be prompted for a
Bootworks boot disk when performing tasks from DOS.
Example: BootDiskMessageUsage= 0 for Never;
BootDiskMessageUsage=1 for Always;
BootDiskMessageUsage=2 if Bootworks is not
detected; BootDiskMessageUsage=3 if PXE is not
detected; and BootDiskMessageUsage=4 if neither
BootWorks nor PXE is detected.
Other
Parameters Details