1 - 4 Symbol LS9203/LS9203i Product Reference Guide
Configuring the Scanner
To configure the scanner, use the bar codes included in this manual. Refer to Chapter 4, User Preferences for
information about programming the scanner using bar code menus.
The scanner supports RS-232, Keyboard Wedge, Wand Emulation and USB to interface to a host system. Each
host specific chapter describes how to set up each of these connections.
Removing the Interface Cable
To remove the interface cable:
1. Unplug the installed cable’s modular connector by depressing the connector clip and gently pulling back.
2. Follow the steps for Installing the Interface Cable on page 1-3 to connect a new cable.
To Next Page
Loading...
