4 - 2 Symbol LS9203/LS9203i Product Reference Guide
Errors While Scanning
Unless otherwise specified, if an error is made during a scanning sequence, just re-scan the correct parameter.
User Preferences Default Parameters
Table 4-1 lists the defaults for user preferences parameters. To change any option, scan the appropriate bar
code(s) provided in the User Preferences section beginning on page 4-3.
NOTE See Appendix A, Standard Default Parameters for all user preferences, hosts, symbologies, and
miscellaneous default parameters.
Table 4-1
User Preferences Default Table
Parameter Default Page Number
User Preferences
Set Default Parameter All Defaults
4-3
Beeper Tone High
4-5
Beeper Volume High
4-7
Laser On Time 3.0 Sec
4-8
Beep After Good Decode Enable
4-9
Time-out Between Same Symbol 0.6 sec (LS9203)
0.5 sec (LS9203i)
4-10
Time-out Between Different Symbols 0.2 sec
4-10
Time Delay to Low Power Mode 30 Minutes
4-11
To Next Page
Loading...
