Chapter 6 RS-232
Introduction
This chapter covers RS-232 host information for setting up the scanner. The RS-232 interface is used to attach the
scanner to point-of-sale devices, host computers, or other devices with an available RS-232 port (e.g., com port).
If the particular host is not listed in Table 6-2 on page 6-4, set the communication parameters to match the host
device. To set communication parameters for hosts not listed, refer to the documentation for the host device.
Throughout the programming bar code menus, default values are indicated with asterisks (
*).
NOTE This scanner utilizes TTL RS-232 signal levels, which will interface with most system architectures. For
system architectures requiring RS-232C signal levels, Motorola offers different cables providing the TTL to
RS-232C conversion. Please contact the Global Customer Interaction Center for more information.
*Baud Rate 9600
Feature/Option
* Indicates Default
To Next Page
Loading...
